Rub Rails only. Big protection with a clean look.
Every set uses 3/8" steel plate flanges, gusseted support tubes, 2" x 2" 3/16" wall square tube rub rails.
P&P Engineering sliders for the second gen Xterra use a unique mounting system consisting of a thick wall high strength steel alloy sleeve around grade 8 hardware through existing holes in the vehicle frame. These sliders require no modification of the vehicle. All our rock sliders bolt on, using the OEM holes in the frame rails. They do not require any welding or drilling.
All P&P Engineering sliders can be prepared to accept our upcoming bolt-on tube fender protectors. The front cap will be made to be removable and will be replaced by a section that bolts to the P&P Engineering front tube bumper to create an exoskeleton to protect the front of your vehicle from damage while off road.
The sliders will come in unfinished steel. We recommend a finish of spray on bedliner prior to installation. If we powdercoated these you would rub it off and have to paint over it down the line anyway. We pass the savings on to you. We do have finishing options available at an additional cost if you would like them to arrived finished and ready to bolt on. Bedliner or powder coating is available.
MADE IN USA
Please allow up to 1 week for shipping.
Grade 8 or better mounting hardware included.Sliders are drilled for Second Generation Xterra's with standard mounting or a 2" body lift. Sliders Fit Second Gen model year. (2005,2006,2007,2008,2009,2010,2011,2012,2013,2014, 2015)